While loading paper into the printer (roll or sheet), the printer has found that it is either too wide or too long (only for sheet) to be loaded properly. Press the Enter key to stop the load. Paper too big to scan the pattern after printing it During the paper loading for the Calibration routine, the printer has detected that the paper will not be loadable later when it will be needed for scanning. The minimum size required for the print is 65 cm (25 inches) long and 50 cm (20 inches) wide. Load a smaller sheet that satisfies this minimum requirement.
While loading paper into the printer (roll or sheet), the printer has found that it is either too narrow or too short (only for sheet) to be loaded properly. Press the Enter key to stop the load process. Paper too small for a diagnostic print The Troubleshooting utility has found that the single sheet loaded in the printer is too small for a Diagnostic Print . Load a roll of paper, or a sheet that is A3-size or larger.
Message Front-Panel Error Messages 35 Paper too big Press ENTER to retry Press CANCEL to abort Paper too small Press ENTER to retry Press CANCEL to abort Message Explanation and Action Paper too big to scan the pattern after printing it During the paper loading for the Calibration routine, the printer has detected that the paper will not be loadable later when it will be needed for scanning. The minimum size required for the print is 65 cm (25 inches) long and 50 cm (20 inches) wide. Load a smaller sheet that satisfies this minimum requirement.
Paper too small for a diagnostic print The Troubleshooting utility has found that the single sheet loaded in the printer is too small for a Diagnostic Print. Load a roll of paper, or a sheet that is A3-size or larger.