C H A P T E R 3 iPXE iPXE is an enhanced version of the Pre-boot eXecution Environment (PXE), which is an open standard for network booting. This module describes the iPXE feature and how to configure it. Information About iPXE, on page 85 How to Configure iPXE, on page 93 Configuration Examples for iPXE, on page 95 Troubleshooting Tips for iPXE, on page 98 Additional References for iPXE, on page 99 Feature Information for iPXE, on page 99 Information About iPXE About iPXE iPXE is an enhanced version of the Pre-boot eXecution Environment (PXE), which is an open standard for network booting. iPXE netboot provides:
• IPv4 and IPv6 protocols • FTP/HTTP/TFTP boot image download • Embedded scripts into the image • Stateless and stateful address auto-configuration (SLAAC) using Dynamic Host Configuration Protocol Version 4 (DHCPv4) and/or DHCPv6, boot URI, and parameters for DHCPv6 options depending on the IPv6 router advertisement. Netboot Requirements The following are the primary requirements for netbooting: • DHCP server with proper configuration. • Boot image available on the FTP/HTTP/TFTP server. • Device configured to boot from a network-based source. Programmability Configuration Guide, Cisco IOS XE 17.16.x 85