cisco IOS XE 17.16.x — Configuring an ACL for a NETCONF-YANG Session

C H A P T E R 9 NETCONF and RESTCONF Service-Level ACLs This module describes the service-levels ACLs supported on NETCONF and RESTCONF, and how to configure it.

Information About NETCONF and RESTCONF Service-Level ACLs, on page 241 How to Configure NETCONF and RESTCONF Service-Level ACLs, on page 241 Configuration Examples for NETCONF and RESTCONF Service-Level ACLs, on page 244 Additional References for NETCONF and RESTCONF Service-Level ACLs, on page 245 Feature Information for NETCONF and RESTCONF Service-Level ACLs, on page 246 InformationAboutNETCONFandRESTCONFService-LevelACLs Overview of NETCONF and RESTCONF Service-Level ACLs You can configure an IPv4 or IPv6 access control list (ACL) for NETCONF and RESTCONF sessions. Clients that do not conform to the configured ACLs are not allowed to access the NETCONF or RESTCONF subsystems.

When service-level ACLs are configured, NETCONF-YANG and RESTCONF connection requests are filtered based on the source IP address. If no service-level ACLs are configured, all NETCONF-YANG and RESTCONF connection requests are permitted into the subsystems. ACL logs are not supported on service-level ACLs. Only named ACLs are supported; numbered ACLs are not supported. Note How to Configure NETCONF and RESTCONF Service-Level ACLs Configuring an ACL for a NETCONF-YANG Session You can either configure an IP access-list or an IPv6 access list for your NETCONF-YANG session. Programmability Configuration Guide, Cisco IOS XE 17.16.x 241