C H A P T E R 11 gRPC Network Operations Interface The Google Remote Procedure Call (gRPC) Network Operations Interface (gNOI) is a suite of microservices, each corresponding to a set of operations. This module describes the supported gNOI services. Information About the gRPC Network Operations Interface, on page 275 Additional References for the gRPC Network Operations Interface, on page 290 Feature Information for the gRPC Network Operations Interface, on page 291 Information About the gRPC Network Operations Interface gNOI Protocol gNOI defines a set of gRPC-based microservices for executing operational commands on network devices.
The gNMI service defines operations for configuration management, operational state retrieval, and bulk data collection through streaming telemetry. gNOI only allows the adoption of services that a device supports. gNOI supports the OS installation service. gNOI can be used with or without user authentication. User authentication is disabled by default. Use the gnxi secure-password-auth command to enable user authentication. For information about enabling user authentication through the OpenConfig model, see https://github.com/YangModels/yang/blob/master/vendor/ cisco/xe/1751/openconfig-system-management.yang . The gNOI protocol supports the following operations:
• Certificate Management • Bootstrapping • OS Installation Service • Factory Reset Service Certificate Management Service The Certificate Management Service primarily exports two main RPCs, Install and Rotate, that are used for the installation of new certificates, and the rotation of existing certificates on a device, respectively. The following RPCs are supported by the Certificate Management Service: Programmability Configuration Guide, Cisco IOS XE 17.16.x 275