5.2 Getting Started DANGER After unpacking the device, make sure that the device has not been damaged during transportation. If the device was kept for a long time at a temperature below minus 20 °С, then before turning it on and starting work, it should be kept in a room with a temperature corresponding to the operating range for 30 minutes. To connect the device: 1. Connect the Device to a power source. CAUTION Before applying power to the Device, check that the supply voltage and its level are correct. 2. Connect primary transducers to the device inputs. 3. Apply power to the device. 4. Set up the device. 5. Make a test run of the device algorithm to verify that the settings are correct.
6. Power off the device. 7. Connect operating mechanisms to the device outputs. 20