Installing right cylinder head Adjustment specification e Caution: When assembling, always start with the right cylin- der. gear carrier. • Check setting again with timing chain tensioner installed. 11.57 RS110961 Right cylinder = at TDC on ignition stroke: marks (arrows) on chainwheel/auxiliary shaft and chain sprocket/crankshaft are aligned. X RS110150 • Locate ignition-stroke TDC with insert pin, BMW No. 11 2 650, at hole in clutch housing and engine block. L Note: With the engine installed, adjust TDC with dial gauge holder, BMW No. 00 2 650, and dial gauge, BMW No. 00 2 510. Right cylinder = at TDC on ignition stroke: Locating pin (arrow) on right camshaft sprocket points downwards.
Mark (R or arrow) and tip of tooth on right camshaft sprocket is precisely aligned with mark X on timing X RS110150