Delta Electronics — 9.1.2 Definitions of Common Network Terms

AS Series Operation Manual 9.1 Introduction 9.1.1 EtherNet/IP EtherNet/IP (“IP” stands for “Industrial Protocol”) is an industrial Ethernet network managed by ODVA, Inc. (formerly Open DeviceNet Vendors Association, Inc.), a global trade and standards development organization. EtherNet/IP works on a TCP/UDP/IP based Ethernet network and uses the most widely deployed collections of Ethernet standards to provide a broad range of applications in different industries that require high-speed and stability including Factory Automation (FA), Building Automation (BA), Process Automation (PA) and many more.

Delta covers a full range of controller and drive products supported by EtherNet/IP, including Programmable Logic Controllers (PLC), inverters, Human Machine Interfaces (HMI) and so on. Refer to Section 9.9 for a full product list that support EtherNet/IP. In addition, you can also use EDS files to connect to other brands of EtherNet/IP devices. You can run Delta EtherNet/IP software (EIP Builder) through the ISPSoft software. Download the ISPSoft software at:

http://www.deltaww.com/services/DownloadCenter2.aspx?secID=8&pid=2&tid=0&CID=06&itemID=060301&typeID=1&d ownloadID=,&title=--%20Select%20Product%20Series%20--&dataType=8;&check=1&hl=en-US 9.1.2 Definitions of Common Network Terms _9 9-4 Term Definition ODVA Open DeviceNet Vendor Association for EtherNet/IP EIP EtherNet/IP, an industrial Ethernet network, provides interoperability for system providers. IP stands for Industrial Protocol. The term “EIP” (EtherNet/IP) is used in this manual. I/O Connection Use the I/O connection to connect to EtherNet/IP and to exchange data cyclically. Explicit Message Connect to EtherNet/IP and to exchange data non-cyclically.

Data is exchanged piece by piece through instructions. RPI Requested Packet Interval, through the I/O connection to connect to EtherNet/IP to exchange data at regular time intervals. ACD Address Conflict Detection to detect IP address duplications. Produced/Consumed TAG (P/C TAG)  You use TAGs for assigning and referencing memory locations for Rockwell PLCs, the same as registers for Delta PLCs.  Produced tag: A tag that a controller makes available for other controllers. Multiple controllers can simultaneously consume (receive) the data. A produced tag sends its data to consumed tags (consumers) without using logic.  Consumed tag: A tag that receives the data of a produced tag.

The data type of the consumed tag and the produced tag must match (including any array dimensions).  The data is transferred over Ethernet/IP. For example, PLC-A needs data from PLC-B, so PLC-B sends the data to PLC-A. Therefore, PLC-B is the producer and PLC-A is the consumer.