Chapter 9 Ethernet Specification and Operation Notes Enable BOOTP: when the IP address receiving mode is BOOTP (BOOTP is enabled), the IP address is assigned, and the device sends out BOOTP requests for IP addresses during each power-on. Enable DHCP: when the IP address receiving mode is DHCP (DHCP is enabled), the IP address is assigned, and the device sends out DHCP requests for IP addresses during each power-on. Disable DHCP/BOOTP: when BOOTP is disabled, the device does not send out any DHCP/BOOTP requests for IP addresses during each power-on. 9.4.2.4 Re-enable BOOTP/DHCP To enable the DHCP or BOOTP function again, use the device software to make the change.
Using the AS Series as an example: from the Start menu, start ISPSoft, then HWCONFIG, and then IP Manager. In IP Manager sets the IP address to the receiving mode. Open HWCONFIG Set up parameters Download HWCONFIG Set up IP receiving mode Open EIP Builder Open IP Manager 9_ Steps to set device parameters 1. Refer to Section 9.4.1.1 for how to start HWCONFIG. 2. Set the parameters: enable the IP address receiving mode to BOOTP/DHCP. 9-21