Chapter 10 CANopen Function and Operation 4) The list below shows the Delta network products for the CANopen network. 10 10-9 Product Model Function AS332T-A AS332P-A AS324MT-A AS320T-B AS320P-B AS300N-A The AS300 series PLC can function as the CANopen master or slave when you install an AS-FCOPM function card. The AS-FCOPM is equipped with a 120 ohm resistor controlled by a switch. AS228T-A AS228P-A AS228R-A AS218TX-A AS218PX-A AS218RX-A AS200 Series PLC is built with CAN communication port. The CAN port conforms to the basic communication protocol CANopen DS301. It supports master and slave modes. The CAN communication terminal is equipped with a 120 Ω resistor.
You can use a short circuit to use this resistor. DVP32ES200RC DVP32ES200TC The DVP-ES2-C series PLC has a built-in CAN interface. It can function as the CANopen master or slave. DVPCOPM-SL DVPCOPM-SL is a module connected to the left side of an S series PLC. It can function as the CANopen master or slave. The PLCs that you can connect to the DVPCOPM-SL are the DVP-28SV, DVP-28SV2, DVP-SX2, DVP- SA2, and DVP-EH2-L. IFD9503 The IFD9503 gateway converts CANopen to Modbus, and connects a device (with an RS- 232 or RS-485 interface) that conforms to the standard Modbus protocol to a CANopen network. You can connect up to 15 devices.
DVPCP02-H2 The CANopen slave module is connected to the right side of an EH2 series PLC. It can connect the EH2 series PLC to a CANopen network. IFD6503 This analyzes CANopen network data, and has ports both ends for a CAN interface and a USB interface. Use it to monitor CAN network data, or allow CAN nodes to transmit the data. The product is used with the Netview Builder software.