Delta Electronics — 10.3.2 The CANopen Communication Object

Chapter 10 CANopen Function and Operation  The following table shows the structures of the SDO requested message and reply message. The format of the requested message: The definition of the requested code in the requested message: The format of the reply message: The definition of the reply code in the reply message: 3. NMT (network management object) The CANopen network management conforms to the master/slave mode. Only one NMT master exists in the CANopen network, and all other nodes are considered to be slaves. NMT includes three services: module control, error control, and boot-up services.

 Module control services The master node in the CANopen network controls the slave by sending commands. The slave receives and executes the command, and does not need to reply. All CANopen nodes have internal NMT states. The slave node has four states: initialization, pre-operational, operational, and stop states. The following diagram illustrates the device states.

10 10-15 COB-ID Byte 0 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Byte 7 600(hex) +Node-ID Requested code Object index Object subindex Requested data LSB MSB bit7-0 bit15-8 bit23-16 bit31-24 Request code (hex) Description 23 Writing 4-byte data 2B Writing 2-byte data 2F Writing 1-byte data 40 Reading data 80 Stopping the current SDO function COB-ID Byte 0 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Byte 7 580(hex) +Node-ID Reply code Object index Object subindex Reply data LSB MSB bit7-0 bit15-8 bit23-16 bit31-24 Reply code (hex) Description 43 Reading 4-byte data 4B Reading 2-byte data 4F Reading 1-byte data 60 Writing 1/2/4-byte data 80 Stopping the current SDO function