4.3 Sliding Rail Kit for Rack Mounting Table 4-2. Rail Kit Fasteners and Hardware NOTE: To prevent fasteners from loosening because of vibration, use thread locking liquid (except where electrical grounding is a requirement). Additional Information : Extra fasteners are provided for various rack mounting configurations. Items Required to Install the Sliding Rail Kit The following items are required to install the Sliding Rail Kit. l Phillips torque screwdriver with #2 bit. l Something to mark the rack post mounting positions such as a scribe or marker.
l A clamping device or other means to temporarily hold the rail in position while fasten- l Thread locking liquid (Loctite ® Blue 242 adhesive or equivalent). ing. Determine the Mounting Method for the Sliding Rail Kit The sliding rail kit adapts to different rack post profiles in several ways. Use the supplied L- brackets to determine which fastener holes you will use to attach the sliding rail kit to the rack posts. Adjust the position of the L-brackets to contact the inner or outer surfaces of the rack post to confirm hole alignment. NOTE: The front and rear outer L-brackets might attach directly to the post without requiring the inner L-brackets for some rack profile types.
Determine the Sliding Rail Kit Installation Location on the Rack Determine the installation location as follows. 1. Determine the rack post height (U location) where you want to install the appliance. 2. Use a marking device to indicate the installation location on all four rack posts. Remove the Sliding Rail from the Sliding Track Remove the sliding rail [1] from the sliding track [2] as follows. 22 EM2100 Installation Guide 20569-000 Rev. A Item Quantity M5x15 screw 2 M5x8 screw 10 M4x6 screw 14 M4x5 screw 12 M4x4 screw 10 M4 hex nut 8 M4 washer 10