Chapter 3: Fleet Manager Configuration and Operation configuration. The user interface for SetNetGo on an EM2100 provides a different set of parameters and options compared to SetNetGo on an AMR. The upper left of the screen shows SetNetGo - FLEET or SETNETGO - LD, depending on your SetNetGo context (the device on which it runs, such as the Omron LD-series AMRs). Configure Access and Security After you connect to the Maintenance Port as described in: Set the IP Address on a Client PC's Network Adapter on page 23 you can open the SetNetGo web interface. Connect your browser to SetNetGo and configure SetNetGo access as follows: 1.
In the SetNetGo web interface, click the Security Tab and then click SetNetGo Access and check Enabled next to the following: Maintenance Interface is automatically enabled. l Wireless Ethernet/User LAN Ethernet l (Optional) Remote Reboot. 2. Change the account password (default is no password) as required and click Apply . NOTE: Passwords are limited to a maximum of 20 alphanumeric characters. For increased security, specify a long (10+ characters) password string with both uppercase and lowercase letters. Include several integers. 3.5 Configure Management Interface Network Settings To configure the Management Network, you require: l A dedicated static IP address. (Do not use 1.2.3.4.
That address is permanently assigned to the Maintenance Ethernet port.) l The subnet mask for the Management network. l The IP address of the network Gateway. l The IP address of a Domain Name Server (DNS) (this is only required if any hostnames will be used in the Fleet Manager configuration), so that the Fleet Manager can resolve all IP addresses. Configure the Management Interface network connections as follows: 1. In the SetNetGo web interface, click the Network Tab . 2. Click Management Interface and enter the: a. IP address. b. Subnet mask. c. Network Gateway IP address (typically a router). 3.
Enter the IP address of your Domain Name Server (DNS), if required for devices other than the appliance and the fleet. Otherwise, leave it as 0.0.0.0. 4. Click Apply . 24 Fleet Operations Workspace Core User's Guide 20569-020 Rev. A