ROLAND — Back Cover

••• BOSS ME-6 TURBO FACTS ••• The ME-6 is a versatile effects processor featuring a user-friendly, floor-pedal design and six popular effects that can be combined simultaneously with noise-free performance. It has real analog distortion and overdrive which can be configured and saved to 15 patch locations. • Compressor 1) Turn COMPRESSOR on by pressing footswitch #1. 2) Cursor over to COMPRESSOR SUSTAIN. 3) Set to 10 using VALUE. • Initializing • Reverb 1) Turn Reverb on by pressing footswitch #6. 2) Cursor over to REVERB MODE. 3) Set the MODE to 1-4. 1) Turn power off. 2) Press and hold CURSOR DOWN and LEFT. 3) Turn power on. 4) Press WRITE. • Writing to Manual Memory 1) Press WRITE.

2) Press MANUAL twice. 3) Press WRITE again. • Choosing Patches 1) Press bank (B) footswitch and choose bank 2 with #2 footswitch. Choose patch 4 Mega Stack. 2) Choose patch 5 (in bank 2) Chorus Distortion. 3) Press bank (B) footswitch and choose bank 3 with #3 footswitch. Choose patch 3 Clean Chorus. 4) Choose patch 1 (in bank 3) Sweet Overdrive. • Manual Mode Manual mode can be used to turn on and off individual effects with the pedals of the ME-6. This allows a user to treat the ME-6 as 6 separate effects pedals. • Audition Distortions 1) Press MANUAL. 2) Individual effects can now be turned on/off at will with the footswitches, just as if you had individual BOSS compact pedals.

1) Choose patch bank 2, number 4. 2) Press EDIT/ESC (you are now in edit mode). 3) Press the left/right cursors until OVERDRIVE/DISTORTION flashes. 4) The parameter LED (on the right) should be on MODE, if not press the up cursor until you’re at the top. 5) Use VALUE up/down to select modes. The correlation of footpedal-to-effect is as follows: 1) Compressor. 2) Overdrive/Distortion. 3) Equalizer. 4) Delay. 5) Chorus/Flanger. 6) Reverb. 1-Mild overdrive such as a BOSS OD-1. 2-High gain overdrive like a BOSS OD-2. 3-Distortion with a mid boost like a BOSS DS-2. 4-Distortion like a MT-2 Metal Zone with enhanced low end. 5-OD-2 with EQ placed before the EQ.

• Controlling the Volume of the ME-6 in Real- time • Delay 1) Connect a FV-300L, FV-300H or EV-5 to the EXP Pedal with a stereo 1/4 inch cable. 2) The Volume of the ME-6 will be controlled between the Noise Suppressor and the Delay effects. 1) Turn DELAY on by pressing footswitch #4. 2) Cursor over to DELAY TIME. 3) Set to 500 milliseconds (50.) with VALUE. 4) Adjust EFFECT LEVEL (3) and FEEDBACK (1). TBS19 © 1994 Roland Corporation U.S., 7200 Dominion Circle, Los Angeles, CA 90040 Faxback # 20018 12/95 >6 8F:E2C >F=E:67764ED