Downloaded from https://www.everyspec.com MIL-HDBK-1001/5A Table 3 Fasteners for Steep Roofing ROOF MATERIAL FASTENER REQUIREMENTS Asphalt Roll Roofing No. 11 or 12 gauge hot dipped galvanized 3/8-inch (10-millimeters) minimum heads, shank length long enough to penetrate through the roofing and deck or at least 3/4 inch (19 millimeters) into a plywood or lumber deck. Clay or Concrete Tile No. 11; galvanized, yellow metal or stainless steel, shanks to penetrate minimum 3/4 inch (19 millimeters) into sheathing or through it. Asphalt Shingles No.
11 or 12 gauge, hot-dipped galvanized, 3/8-inch (10-millimeter) minimum heads, with shank length long enough to penetrate through the roofing and through a wood panel deck or at least 3/4 inch (19 millimeters) into a lumber deck. Wood Shakes, Shingles Rust-resistant, galvanized or aluminum nails, l4 gauge, 3d x 1-1/4 inch (32 millimeters) long for 16-inch (406- millimeters) and 18-inch (457-millimeter) shingles or shakes; 14 gauge, 4d x 1-1/2 inch (38 millimeter) long for 24-inch (610- millimeter) shingles or shakes. Slate Copper slating nails only. 3d up to 18- inch (457-millimeter) long slates, 4d for 18-inche (457 millimeters) and longer slates, 6d nails at hips and ridges.
Minimum length = 2 x slate thickness + 1 (e.g., 1-1/2 inch (38 millimeter) minimum length for 1/4-inch (6-millimeter) slate). NOTE: "Hot" roofs in cold regions should slope 4 inches per foot (33 percent) or more (with backnailing) and have eave overhangs of less than 12 inches (305 millimeters) to minimize ice dam problems. 39