SAS2-213EL1 Backplane User's Guide Connecting an Internal HBA to the Backplane The following section lists the most common cables used to connect the HBA to the backplane. 1 8 2 J2 1 WWN L396 EXPDBG1 Y9 + + EC2 A C ACT0 1 4 MH1 U16 Rev:1.02 BPN-SAS2-216EL U326 16 17 64 + EC1 + P_ICE_TDO 5 DESIGNED IN USA 10 15 20 25 28 + L37 C858 + C862 C861 PRI_J3 MH2 EC3 + EC5 + Q1 32 + 33 48 49 + + C860 U320 P_ICE_TCK P_ICE_RTCK Y E R K BAR CODE PRI_J2 Q3 MH4 MH3 BCA534 EC6 1 + + C2926 1 4 1 3 A 1 3 AE AH BCA236 BCA234 A R157 SMART_UART R158 PRI_MODE1 R161 PRI_MODE2 R159 PRI_J1 HBA (Host Bus Adapter) MDIOINTERFACE Figure 3-3:
Single Internal Host Bus Adapter Supported Internal HBA Cables Use the following cables to create connections between the internal HBA and SAS2- 213EL model backplane. The cables required depend upon the HBA connector. Cable Name: iPass (Mini-SAS) to iPass (Mini-SAS) Part #: CBL-0108L-02 Length: 39 cm (15 inches) Part #: CBL-0109L-02 Length: 22 cm (9 inches) Part #: CBL-0110L-02 Length: 18 cm (7 inches) Description: This cable has an iPass (SFF-8087/Mini-SAS) connector (36-pin) at each end. It connects from the HBA to the SAS2-213EL model backplane. 3-3