SC-B9580 User's Guide Appendix Supported Media Warning: ❏ To prevent ground leak accidents, connect to a grounded (earthed) outlet. Connecting to anything other than a grounded outlet could result in electric shock or fire. Check the electrical outlet that will be used. If the outlet is not grounded, contact your dealer. The following media can be used with the printer. Print quality is greatly affected by the type and quality of media used. Choose a media suited to the task at hand. For information on use, refer to the documentation supplied with the media or contact the manufacturer. Before buying media in large quantities, try printing on a smaller sample and check the results.
❏ Use only the type of power source indicated on the printer's label. An electric shock or fire could occur. c Important: Do not use media that is wrinkled, scuffed, torn, or dirty. ❏ Do not connect the power cable to a power strip or multi plug. An electric shock or fire could occur. Connect the power cable directly to an outlet for domestic use. Roll media Caution: Do not tilt the product more than 10 degrees forward or back while moving it. Failure to observe this precaution could result in the printer falling over, causing accidents. c Important: ❏ The printer can be moved across bumps of less than 5 mm (0.19 in.) and gaps of less than 20 mm (0.78 in.).
Before you start, check the bumps and gaps of the route to move the printer. Moving and Transporting the Printer ❏ When moving over bumps or across gaps, disconnect the bulk ink solution and move it separately from the printer. This section describes how to move and transport the product. ❏ Move the printer with the ink supply units installed. Moving the Printer Getting Ready This section explains how to move the printer to another location on the same floor, assuming there are no bumps or gaps in the floor or that if there are bumps or gaps, they are within allowable specifications.
See the following for information on moving to a floor with bumps or gaps that exceed the allowable specifications, floors that slope, and how to move to another floor or building. Preparing to move when there are no bumps or gaps A Confirm that the printer is off. B Remove the waste ink bottle. U “Replacing the Waste Ink Bottle” on page 66 U “Transport” on page 120 110 Roll core size 2 or 3 inch Roll outer diameter 250 mm (9.84 in.) or less Media width 300 mm (11.8 inches) to 1625.6 mm (64 inches) Media thickness 0.04 to 1.00 mm (0.001 to 0.03 in.) Roll weight Maximum 45 kg (99 lbs)