SC-B9580 User's Guide Introduction G Media feeding unit Loads media to be used for printing. See the following for supported media. U “Supported Media” on page 110 H Media holder Place media on these holders. There are same parts on both the left and the right. I Drive switch Rewinds media during media replacement. J Casters There are two casters on each leg. Once installation is complete, the casters should be kept locked while the printer is in use. K Levelers There are two levelers on each leg. When installing on a carpeted floor or a sloping floor, check level gauge of the printer and adjust these to keep the printer stable.
If you perform horizontal adjustment during installation, make sure you raise the levelers above the casters before moving the printer. L Pressure roller spacer This part fixes the pressure rollers in the open position. Pressure rollers that have spacers inserted do not apply pressure to the media, even when the media loading lever is flipped forward. If you use the presser roller spacer when wrinkles occur on the media end, the wrinkles may be improved. If you are not using the presser roller spacer, store it by inserting it into its original place. U “How To Use Pressure Roller Spacers” on page 120 M Media cleaner Wipes off any lint or dust on the media when the media is being fed.
If a message appears on the control panel's screen, use the supplied media cleaner brush for cleaning. U “Cleaning the Media Cleaner” on page 64 N Media loading lever This operates in tandem with the media loading lever at the front. Operate whichever is the easiest to use in your situation. O Vent This opening allows for ventilation between the printer's inside and outside. Do not block the vent. 12