SC-B9580 User's Guide Introduction F Heater temperature Displays the set heater temperature. The icon next to the number and the background color changes, as shown below, depending on the temperature of the heater. Press this area to display the settings screen where you can change the values. G Preheat Start/Stop The heater starts heating when a job is sent, and printing starts when it reaches the set temperature. Press Preheat Start to start pre-heating the heater. Pre-heating allows you to start printing quickly once a job has been sent. You can start/stop pre-heating for the heater each time you press this area.
When pre-heating, the heater enters standby mode at a temperature slightly lower than the set temperature. Additionally, the heater turns off after the time set in Sleep Timer in the settings menu has elapsed. Heating starts when a print job is sent, but you can still press Preheat Start if necessary. Also, if Heater is set to Off in the settings menu, pressing Preheat Start does nothing and pre-heating does not start. H Platen Gap Displays the Platen Gap settings for the current media information ( C ). Press this area to display the settings screen where you can change the values.
I Notice on when to perform Periodic Cleaning Displays the remaining print duration, print page counter, or print length until Periodic Cleaning is performed when the following conditions are met. ❏ Periodic Cleaning (Print Duration): 24 hours in advance ❏ Periodic Cleaning (Print Page): 40 pages in advance ❏ Periodic Cleaning (Print Length): 60 m in advance You can press this area to perform Head Cleaning if necessary. J (Printer Status) . Press Message List on the screen displayed when you press this area to display a list of warning notifications. You can check detailed information and the handling procedure for each item by pressing it in the list.
Items are removed from the list as those actions are taken. If a warning notification has been generated, is displayed on the right just like K (link to manual) Displays a QR code that takes you directly to the online manual. Depending on your country or region, the QR code may take you directly to the Epson Video Manuals. 19 Status Background Color Icon Stopped (heater low temperature) Gray - Ready to print, preheating, waiting to stabilize Lit orange - Preparing to print or preparing to preheat Flashing orange