SC111 Chassis Manual C-5 Front Connector and Pin Definitions 1. Backplane Main Power Connectors The 4-pin connectors designated JP10 pro- vides power to the backplane. See the table on the right for pin definitions. 2. - 5. SAS Ports The SAS ports are used to connect the SAS drive cables. The four ports are designated #0 - #3. Each port is also compatible with SATA drives. 6. Sideband Header The sideband header is designated JP51. For SAS-2 to work properly, you must connect an 8-pin sideband cable. See the table to the right for pin definitions. 7. I 2 C Connectors to monitor HDD activity and status. See the table on the right for pin definitions.
The I 2 C Connector, designated JP44, is used C-4 Backplane Main Power 4-Pin Connector (JP10) Pin# Definition 1 +12V 2 and 3 Ground 4 +5V Sideband Headers (JP51) Pin # Definition Pin # Definition 2 SDIN/ Backplane Addressing (SB5) 1 Controller ID (SB6) 4 SDOUT/I2C Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SDA (SB1) 8 Backplane ID (SB7) 7 SCL (SB0) 10 No Connec- tion 9 No Connec- tion I2C Connector Pin Definitions (JP44) Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection