SC111 Chassis Manual C-6 Front Jumper Locations and Pin Definitions MH3 MH2 J8 BZ1 C20 + + JP35 JP33 3 1 1 U25 + C32 +5V GND GND +12V C33 MADE IN TAIWAN C85 C5 C26 #3 3 SIDEBAND 2-3:I2C 1-2:SGPIO JP33:MODE SEL 11 23 C159 C157 Y1 MH1 C18 C45 1 4 JP10 JP51 JP44 I2C DESIGNED IN USA + C65 1 3 + JP18 R71 C84 C19 A C J7 33 C149 #1 J6 C44 + J5 D3:ALARM D3 34 44 C151 U19 6 5 1 JP46 2 UPGRADE REV 1.01 SAS809TQ #0 MADE IN TAIWAN + 1 3 JP18 R71 C65 JP18 + Figure C-2: Jumpers Locations Explanation of Jumpers To modify the operation of the backplane, Connector Pins 3 2 1 jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector.
Pin 1 is identified with Jumper a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" 3 2 1 means the jumper is on and "Open" means Setting the jumper is off the pins. C-6 Jumper Settings Jumper Jumper Setting s Note JP18 2-3: Enabled 1-2: Disabled Buzzer Reset JP35 2-3: Default 1-2: Reset MG9071 Reset