Chapter 5 Chassis Setup and Maintenance Chapter 5 Chassis Setup and Maintenance 5-1 Overview This chapter covers the steps required to install components and perform mainte nance on the chassis. The only tool required is a Phillips screwdriver. Review the warnings and precautions listed in the manual before setting up or servicing this chassis. These include information in Chapter 2: Warning Statments for AC Systems , and the warning and precautions listed in the setup instructions 5-2 Removing the Power Cord Before performing most maintenance tasks, use the following procedure to ensure that power has been removed from the system. 1.
Use the operating system to power down the system, following the on-screen prompts. 2. After the system has completely shut-down, carefully grasp the head of the power cord and gently pull it out of the back of the power supply. If your system has dual power supplies, remove the cords from both power supplies. 3. Disconnect the cord from the power strip or wall outlet. 5-1