SC113 Chassis Manual B-7 Front Jumpers and LED Indicators JP29 JP18 MH3 MH4 MH2 JP13 GND +5V GND +12V +5V GND GND +12V 5 6 1 + C6 J12 I2C#2 SB#2 JP52 JP10 + C5 2-3:I2C 1-2:SGPIO JP33:MODE SEL J8 SB#1 48 33 JP51 9072 RST UPGRADE JP29 1 2 JP46 + C285 J6 MH5 + C98 C137 + C4 #7 J16 MH6 #6 J14 BUZZER RST 1 + #5 #4 J10 U18 JP45 #3 #2 J7 R259 I2C#1 JP33 JP44 49 64 REV 1.02 J5 #1 #0 MH1 Figure C-2: Front Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector.
Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Jumper 3 2 1 Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: 1. Hard drive failure 2. Fan failure 3. System temperature over 45є Celsius. B-6 Jumper Settings Jumper Jumper Settings Note JP18 Open: Enabled Closed: Disabled Buzzer Reset* JP29 Open: Default Closed: Reset MG9072 Chip Reset