SC113M Chassis Manual 3-2 Control Panel Button and LEDs There are two push-buttons located on the front of the chassis. These are (in order from left to right) a reset button and a power on/off button. Reset: The reset button is used to reboot the system. Power: The main power switch is used to apply or remove power from the power supply to the server system. Turning off system power with this button removes the main power but keeps standby power supplied to the system. Therefore, you must unplug system before servicing. Unit Identification LED :
The Unit Identification LED is used to indicate fan failure, power failure, overheat condition, or to identify the unit within a large rack instal lation. The feature requires a motherboard that supports the Universal Information LED. When this LED blinks red quickly, it indicates a fan failure and when blinking red slowly a power failure. This LED will be blue when used for UID (Unit Identifier). When on continuously red, it indicates an overheat condition, which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. See the table below for descriptions of the LED states 3-2