Chapter 4 Chassis Setup and Maintenance Chapter 4 Chassis Setup and Maintenance 4-1 Overview This chapter covers the steps required to install components and perform mainte nance on the SC113M chassis. The only tool you will need to install components and perform maintenance is a Phillips screwdriver, and under certain circumstances, a hex wrench. Print this page to use as a reference while setting up your chassis. 4-2 Removing Power From the Chassis Prior to installing components or performing maintenance, the chassis must be powered off and completely disconnected from any power source Removing Power From the Chassis 1.
Power down the system using the on-screen prompts in the operating system. 2. Grasp the head of the power cord and unplug the power cord from the back of the power supply. If your system includes a redundant power supply, re move the power cords from both power supplies. Review the warnings and precautions listed in the manual before setting up or servicing this chassis. These include information in Chapter 2: Standardized Warn ing Statements for AC Systems and the warning/precautions listed in the setup instructions. 4-1