SC113M Chassis Manual Figure 4-3. Removing the Dummy Drive From the Carrier Installing a Hard Drive into a Carrier 1. Remove the four screws securing the dummy drive to the hard drive carrier and set them aside for later use. 2. Lift the dummy drive up and out of the carrier. 3. Insert a drive into the carrier with the printed circuit board side facing down ward, with the connector oriented at the rear of the carrier. 4. Align the drive in the carrier so that the mounting holes in the drive align with the mounting holes in the carrier. Note that there are holes in the carrier marked “SATA” to aid in correct installation of the drive. 5.
Secure the drive to the carrier with four screws previously set aside. 6. Insert the drive carrier into the chassis drive bay, keeping the carrier oriented so that the hard drive is on the top of the carrier and the release button is on the right side. When the carrier reaches the back of the drive bay, the release handle will retract. 7. Push the handle in until the drive carrier clicks into the locked position. 4-4