SC113M Chassis Manual C-6 Rear Connector and Pin Definitions #1. Backplane Main Power Connectors The 4-pin connectors designated JP10, provide power to the backplane. See the table on the right for pin definitions. #2 Upgrade Connector The Upgrade connector, designated JP46 is for diagnostic purposes only. This connector should only be used by a certified and experi enced technician. #3. MG9072 Chip The MG9072 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. #4 and #5. Sideband Headers The sideband headers are designated JP51 and JP52. For SES-2 to work properly, you must connect an 8-pin sideband cable. See the table to the right for pin definitions.
C-4 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V Sideband Headers Pin # Definition Pin # Definition 2 SDIN/ Backplane Addressing (SB5) 1 Controller ID (SB6) 4 SDOUT/I2C Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SLOAD/ SDA (SB1) 8 Backplane ID (SB7) 7 SCLOCK/ SCL (SB0) 10 No Connec tion 9 No Connec tion