Supermicro SC213L — Supermicro SC213L Chassis Series User Manual

SC213L Chassis Manual C-7 Front Jumper Locations and Pin Definitions JP84 6 5 1 JP69 UPGRADE 2 U24 MH1 MH2 JP53 1 2 SB#1 SB#2 I2C#2 7 8 R603 JP37 JP95 R365 3 1 2-3:I2C 1-2:SGPIO JP84:MODE JP84 R614 JP51 1 2 7 8 I2C#1 SAS213LTQ REV: 1.00 JP35:9072 RST 1-2:RST 2-3:NO RST Y1 A C D3 ALARM C100 J16 R607 J14 R589 J12 J11 J10 R575 J9 J8 J7 3 1 JP35 7 #7 #6 #5 #4 #3 #2 #1 #0 7 7 7 7 7 7 7 JP35 49 64 1 JP18 BUZZER RST + JP18 + C34 1 F4 + JP13 C144 C145 F3 C35 + + ACT3 ACT2 ACT0 ACT1 ACT7 ACT6 ACT5 ACT4 JP10 + C136 C135 C134 R156 BZ1 R624 C139 R169 C6 4 1 DESIGNED IN USA JP26 ACT_IN C5 4 1 C44 Explanation of Jumpers Figure C-2:

Front Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means Jumper Setting 3 2 1 the jumper is off the pins. *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: 1. Hard drive failure 2. System temperature over 45є Celsius.

C-6 Jumper 1-2 Jumper S etting 2-3 Jumper Setting JP35 9072 Reset No Reset Jumper Open (Jumpe r Off) Closed (Jumper On) JP18 Buzzer Enabled* Buzzer Disabled*