SC213L Chassis Manual D-6 Front Connector and Pin Definitions 1. Backplane Main Power Connectors The 4-pin connectors, designated JP10, and JP13, provide power to the backplane. See the table on the right for pin definitions. 2. - 9. SAS/SATA Ports The SAS/SATA ports are used to connect the SAS drive cables. The eight SAS IN ports are designated #0 - #7. 10. ACT_IN: The activity LED connector designated JP26, is used to indicate the activity status of each SAS drive. The activity LED connector is located on the front panel. For the activity LED connector to work properly, connect using a 10-pin LED cable. This is only used when the activity LED is not supported by the hard drive.
D-4 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V SAS Activity LED Header Pin Definitions Pin# Definition Pin# Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground X Empty