Super Micro Computer, Inc. SC502 — Super Micro SC502 Chassis Manual: Comprehensive Guide for System Integrators

Chapter 5: Chassis Setup and Maintenance 5-8 Power Supply The SC502 chassis has a 200 Watt power supply. This power supply is auto- switching capable. This enables it to automatically sense and operate at a 100v to 240v input voltage. The SC502 chassis has one power supply. In the unlikely event that the power supply unit fails, the system will shut down and you will need to change the power supply unit. New units can be ordered directly from Supermicro (see contact information in the Preface). Replacing the Power Supply Replacing the Power Supply Unplug all power leading to the chassis. 1. Disconnect all wiring from the power supply. 2.

Remove the four screws which hold the power supply in the chassis. Two rear 3. mounting screws are located on the rear of the power supply. Two bottom Rear Mounting Screws Power Supply Mounting Thru Holes Bottom Mounting Screws Figure 5-10: Installing the Power Supply 5-9