Chassis Manual 4-2 Control Panel Buttons There are two push-buttons located on the front of the chassis. These are (in order from left to right) a reset button and a power on/off button. l Reset: The reset button is used to reboot the system. l Power: The main power switch is used to apply or remove power from the power supply to the server system. Turning off system power with this but- Therefore, you must unplug system before servicing. ton removes the main power but keeps standby power supplied to the system. 4-3 Control Panel LEDs The control panel located on the front of the SC512F chassis has fi ve LEDs.
These LEDs provide you with critical information related to different parts of the system. This section explains what each LED indicates when illuminated and any corrective action you may need to take. l Overheat/Fan Fail: When this LED fl ashes it indicates a fan failure. When caused by cables obstructing the airfl ow in the system or the ambient room tem- continuously on (not fl ashing) it indicates an overheat condition, which may be perature being too warm. Check the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that the chassis covers are installed. Finally, verify that the heatsinks are installed properly.
This LED will remain fl ashing or on as long as the overheat condition exists. 4-2