Chassis Manual Add-on Card/Expansion Slot Setup SC512F chassis includes a slot for one full height/full length add-on card and a riser card. The riser card allows the add-on to fi t within the small 1U form. The add-on card slot does not require a screw to hold the card in place. Add-on Card Slot latch Add-on Card Slot Shield Figure 5-9: SC512F LP model To install add-on and expansion cards 1. Disconnect the power supply, lay the chassis on a fl at surface, and open the chassis cover. 2. Slide the add-on card clip upward. 3. Slide the add-on card slot shield toward the side of the chassis and remove the Shield. 4. Secure the riser card to the motherboard. 5.
Slide the add-on card (with "L" bracket) into the add-on card slot and the riser card. 6. Replace the add-on card slot clip to secure the add-on card. 5-8