Chapter 2 Rack Mount Installation Chapter 2 Rack Mount Installation 2.1 Overview This chapter provides instructions for preparing and mounting your chassis in a rack. By default, the chassis is shipped configured as a tower. The tower top cover and bottom feet must be removed to mount in a rack. Also, the control panel/drive module should be rotated 90 degrees. Mounting rails are optional for this system. Be sure you have received the correct rail kit for your server. 2.2 Preparing for Rack Mounting Choosing a Setup Location The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and electromagnetic fields are generated.
Leave at least 25 inches clearance in front of the rack to open the front door completely. Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient airflow and access for servicing. It should be a restricted access location, such as a dedicated equipment room or a service closet. This product is not suitable for use with visual display workplace devices acccording to §2 of the German Ordinance for Work with Visual Display Units. Rack Precautions Ensure that the leveling jacks on the bottom of the rack are extended to the floor so that the full weight of the rack rests on them. In single rack installations, stabilizers should be attached to the rack.
In multiple rack installations, the racks should be coupled together. Always make sure the rack is stable before extending a server or other component from the rack. 13