Chapter 3: Maintenance and Component Installation Installing the Internal Drives Removing a Hot-Swap Drive Carrier 1. Open the front bezel then push the release button located beside the drive LEDs. 2. Swing the handle fully out and then use it to pull the unit straight out. Note: Your operating system must have RAID support to enable the hot-swap capability of the SATA drives. Figure 3-2. Removing a Drive Carrier Mounting a Drive in a Drive Carrier The SATA drive carriers help to promote proper airflow for the system. For this reason, even carriers without SATA drives must remain in the chassis. 1.
To add a new drive, install it into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 2. Secure the drive to the carrier with the screws provided, then push the carrier completely into the drive bay. You should hear a *click* when the drive is fully inserted. This indicates that the carrier has been fully seated and connected to the midplane, which automatically makes the power and logic connections to the hard drive. 27