Appendix C: BPN-SAS-743TQ Backplane Specifications Rear Connectors and Pin Definitions #1. and #2. JTAG Connector and Upgrade Connectors The JTAG and Upgrade connectors, designated JP47 and JP46, are used for diagnostic purposes. These connectors should be used by a certified and experienced technician. #3. MG9072 Chip The MG9072 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. #4. Backplane Main Power Connectors The 4-pin connectors, designated JP10 and JP13, provide power to the backplane. See the table on the right for pin definitions. #5.
Activity LED Header The activity LED header, designated JP26, is used to indicate the activity status of each SAS drive. The Activity LED Header is located on the front panel. For the Activity LED Header to work properly, connect using a 10-pin LED cable. #6. and #7. Sideband Headers The sideband headers are designated JP51 and JP52. For SES-2 to work properly, you must connect an 10-pin sideband cable. See the table to the right for pin definitions. #8. and #9. I 2 C Connectors The I 2 C Connectors, designated JP44 and JP45, are used to monitor HDD activity and status. See the table on the right for pin definitions. #10. to #17.
SAS Ports The SAS ports are used to connect the SAS drive cables. The eight ports are designated #0 – #7. Each port is also compatible with SATA drives. However, do not mix SAS and SATA drives in the same enclosure. 63 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V Sideband Headers Pin # Definition Pin # Definition 2 Backplane Addressing (SB5) 1 Controller ID (SB6) 4 Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SDA (SB1) 8 Backplane ID (SB7) 7 SCL (SB0) 10 No Connection 9 No Connection I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection