Supermicro SC745 — Appendix C BPN-SAS-743TQ Backplane Specifications

Appendix C: BPN-SAS-743TQ Backplane Specifications *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: hard drive failure, fan failure, or system temperature over 45є Celsius. I 2 C and SGPIO Mode Jumper Settings This backplane can utilize I 2 C or SGPIO. I 2 C is the default mode and can be used without making changes to your jumpers. The following information details which jumpers must be configured to use SGPIO mode or restore your backplane to I 2 C mode. Explanation of Jumpers To modify the operation of the backplane, jumpers can be used to choose between optional settings.

Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Connector Pins 3 2 1 Jumper Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. 3 2 1 Setting 65 Jumper Settings Jumper Jumper Settings Note JP18 Open: Enabled Closed: Disabled Buzzer reset* JP29 Open: Default Closed:

Reset MG9072 chip reset I2C and SGPIO Settings Jumper I2C Jumper Setting (Default) SGPIO Jumper Setting Note JP33 Pins 2-3 Pins 1-2 Controller ID #1 JP34 Pins 1-2:ID#0 Pins 1-2 Backplane ID #1 JP36 Pins 2-3 Pins 1-2 Controller ID #2 JP37 Pins 2-3:ID#1 Pins 1-2 Backplane ID #2 JP38 Closed Open I2C Reset #2 JP40 Open Closed I2C Reset SDOUT #1 JP41 Open Closed I2C Reset SDOUT #2 JP42 Pins 2-3 Pins 1-2 Backplane ID SDIN #1 JP43 Pins 2-3 Pins 1-2 Backplane ID SDIN #2 JP50 Closed Open I2C Reset #1