Appendix C: SAS-809T/TQ Backplane Specifications Jumper Settings and Pin Definitions C-5 Front Connectors and Jumpers 5 6 1 7 9 MH3 MH2 J8 BZ1 C59 + + + #3 JP35 1 JP33 1 3 JP44 3 SIDEBAND 2-3:I2C 1-2:SGPIO JP33:MODE SEL 1-2:RST 2-3:NO RST 9071 RST:
10 U31 C32 +5V GND GND +12V JP10 1 4 JP51 I2C DESIGNED IN USA 11 + C65 1 3 MADE IN TAIWAN + JP18 #2 J7 C148 33 23 12 3 Y1 J6 + C3 + JP25:OH TEMP OPEN:45 C 1-2:50 C 2-3:55 C MH1 2-3:NO RST 1-2:RST BUZZER RST C D3:ALARM D3 R6 4 12 U19 #1 6 5 8 2 1 JP46 2 UPGRADE REV 1.01 SAS809TQ C56 #0 JP25 1 3 The SAS-809T and SAS-809TQ model backplanes have the same printed circuit board, except that the SAS-809T model does not include the MG9071 AMI chip and its supporting components. Front Connectors Power Connector (4-pin) JP10 1. SAS Port #0 J5 2. SAS Port #1 J6 3. SAS Port #2 J7 4. SAS Port #3 J8 5. Sideband JP51 (Not included on the SAS-809T backplane) 6. I 7.
2 C JP44 (Not included on the SAS-809T backplane) Upgrade JP46 (Not included on the SAS-809T backplane) 8. Chip Reset JP35 (Not included on the SAS-809T backplane) 9. Mode Select JP33 (Not included on the SAS-809T backplane) 10. Buzzer Reset JP18 11. MG9071 Chip (not included on the SAS-809T backplane) 12. C-3