Supermicro SC809 — Supermicro SC809 1U Chassis Series User's Manual PDF

SC809 Chassis Manual C-7 Front Jumper Locations and Pin Definitions MH3 MH2 +5V GND GND +12V MADE IN TAIWAN J8 BZ1 C59 + + + #3 JP35 1 JP33 1 3 JP44 3 SIDEBAND 2-3:I2C 1-2:SGPIO JP33:MODE SEL 1-2:RST 2-3:NO RST 9071 RST: U31 C32 JP10 1 4 JP51 I2C DESIGNED IN USA + C65 1 3 + JP18 J7 C148 23 12 Y1 J6 + C3 + JP25:OH TEMP OPEN:45 C 1-2:50 C 2-3:55 C MH 2-3:NO RST 1-2:RST BUZZER RST C D3:ALARM D3 R6 #2 33 U19 #1 6 5 1 JP46 2 UPGRADE REV 1.01 SAS809TQ C56 #0 JP25 3 + 1 3 JP18 C65 + JP18 Explanation of Jumpers BUZZER RST To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector.

Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Connector Pins 3 2 1 Jumper 3 2 1 Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: Hard drive failure 1. Fan failure 2. System temperature over 45є Celsius. 3. C-6 Jumper Settings Jumper Jumper Setting s Note JP18 2-3: Enabled 1-2: Disabled Buzzer Reset* JP35 2-3: Default 1-2: Reset MG9071 Reset