Chapter 5: Rack Installation Chapter 5: Rack Installation 5-1 Overview This chapter provides simple instructions for installing this chassis into a rack. 5-2 Unpacking the System You should inspect the box the chassis was shipped in and note if it was damaged with the carrier who delivered it. in any way. If the chassis itself shows damage you should fi le a damage claim Decide on a suitable location for the rack unit that will hold your chassis. It should be situated in a clean, dust-free area that is well ventilated. Avoid areas where it placed near a grounded power outlet. Be sure to read the Rack and Server heat, electrical noise and electromagnetic fi elds are generated.
You will also need Precautions in the next section. 5-3 Preparing for Setup two rail mounting brackets and the mounting screws you will need to install the The box your chassis was shipped in should include two sets of rail assemblies, system into the rack. Please read this section in its entirety before you begin the installation procedure outlined in the sections that follow. Choosing a Setup Location - Leave enough clearance in front of the rack to enable you to open the front door completely (~25 inches). - Leave approximately 30 inches of clearance in the back of the rack to allow for suffi cient airfl ow and ease in servicing.
- This product is for installation only in a Restricted Access Location (dedicated equipment rooms, service closets and the like). Rack Precautions 5-1