SC813M Chassis Manual Chapter 4 System Interface 4-2 Control Panel Buttons There are two push-buttons located on the front of the chassis. These are (in order from left to right) a reset button and a power on/off button. NIC2: Indicates network activity on GLAN2 when flashing. Reset: The reset button is used to reboot the system. Power: The main power switch is used to apply or remove power from the power supply to the server system. Turning off system power with this button removes the main power but keeps standby power supplied to the system. Therefore, you must unplug system before servicing. NIC1: Indicates network activity on GLAN1 when flashing.
4-3 Control Panel LEDs The control panel located on the front of the SC813M chassis has five LEDs. These LEDs provide you with critical information related to different parts of the system. This section explains what each LED indicates when illuminated and any corrective action you may need to take. HDD: Indicates IDE channel activity. SAS/SATA drive and/or DVD-ROM drive activity when flashing. Information LED: Power: Indicates power is being supplied to the system's power supply units. This LED should normally be illuminated when the system is operating. 4-2 4-3 Informational LED Status Description Solid red An overheat condition has occured. (This may be caused by cable congestion).
Blinking red (1Hz) Fan failure, check for an inoperative fan. Blinking red (0.25Hz) Power failure, check for a non-operational power supply. Solid blue Local UID has been activated. Use this function to locate the server in a rack mount environment. Blinking blue (300 msec) Remote UID is on. Use this function to identify the server from a remote location.