Supermicro SC813M — Appendix C BPN-SAS-815TQ Backplane Specifications

SC813M Chassis Manual Chapter 6 Rack Installation Secure to the Front of the Rack Secure to the Rear of the Rack Attach Outer Racks together Figure 6-3: Assembling the Outer Rails Outer Rack Rails Outer rails attach to the server rack and hold the server in place. The outer rails for the SC813M chassis extend between 30 inches and 33 inches. Installing the Outer Rails to the Rack Figure 6-4: Installing into a Rack 1. Attach the short bracket to the outside of the long bracket. You must align the pins with the slides. Also, both bracket ends must face the same direction. Note: figures are for illustrative purposes only. Always install servers into racks from the bottom up. 2.

Adjust both the short and long brackets to the proper distance so that the rail fits snugly into the rack. Installing the Chassis into a Rack 3. Secure the long bracket to the front side of the outer rail with two M5 screws and the short bracket to the rear side of the outer rail with three M5 screws. 1. Confirm that chassis includes the inner rails and rail extensions. Also, confirm that the outer rails are installed on the rack. 4. Repeat steps 1-3 for the left outer rail. 2. Line chassis rails with the front of the rack rails. 3. Slide the chassis rails into the rack rails, keeping the pressure even on both sides (It may be necessary to depress the locking tabs when inserting).

When the server has been pushed completely into the rack, the locking tabs will "click" into the locked position. 4. (Optional) Insert and tightening the thumbscrews that hold the front of the server to the rack. Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. 6-6 6-7