SC813M Chassis Manual Appendix C BPN-SAS3-815TQ Backplane Specifications C-6 Rear Jumpers and Pin Definitions This backplane can utilize I 2 C or SGPIO. SGPIO is the default mode and can be used without making changes to your jumpers. Use the following settings for I 2 C mode.
I 2 C and SGPIO Modes and Jumper Settings JP29 JP18 JP10 +5V GND GND +12V REV 1.00 SAS815TQ S UPER R #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 JP47 JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET #2 JP46 J7 R144 JP29 #1 J6 J5 JP18 D3 JP42 JP33 JP34 JP50 JP40 JP51 JP44 SIDEBAND 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN MH2 M46 M9 M15 JP50 JP33 JP34 JP42 JP33 JP34 JP40 JP40 JP51 JP42 JP50 SIDEBAND MH2 M46 M9 M15 JP44 2 I C #0 J5 JP26 ACT0 ACT1 ACT2 ACT3 ACT IN Figure C-2. Rear Jumpers Explanation of Jumpers 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector.
Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Connector Pins Jumper Setting 3 2 1 C-6 C-7 SGPIO Jumpers (Default) Jumper JP33 Setting 1-2 Description Controller ID JP34 1-2:ID#0 Backplane ID JP40 Closed I2C Reset SD OUT JP42 1-2 Backplane ID SDIN JP50 Open I2C Reset I2C Jumpers Jumper Setting Description JP33 2-3 Controller ID JP34 1-2:ID#0 Backplane ID JP40 Open I2C Reset SD OUT JP42 2-3 Backplane ID SDIN JP50 Closed I2C Reset General Jumpers Jumper Settings Description JP18 Open: Enabled Closed: Disabled Buzzer Reset JP29 Open: Default Closed:
Reset MG 9071 Chip Reset