SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-8 Power Supply Depending on your chassis model the SC815 chassis has a 330, 560, 600, 650, 700, 710 or 720 Watt power supply. This power supply is auto-switching capable. All power supplies with the exception of the 710 power supply, automatically sense and operate at a 100V to 240V input voltage. The 710 DC power supply operates at -36DC to -75DC. An amber light will be illuminated on the power supply when the power is off. An illuminated green light indicates that the power supply is operating.
Power Supply Failure If the power supply unit fails, the system will shut down the power supply unit and you will need to replace it A power supply failure is indicated by a flashing red (0.25Hz) LED indicator.Replacement power supply units can be ordered directly from Supermicro (see contact information in the Preface). As there is only one power supply unit in the SC815 Chassis, power must be completely removed from the server before removing and replacing the power supply unit for whatever reason. Release Tab Figure 5-16. Removing the Power Supply Replacing the Power Supply 1. Power down the server and unplug the power cord.
If your chassis includes a redundant power supply (at least two power modules), you can leave the server running and remove only one power supply. 2. Push the release tab (on the back of the power supply) as illustrated. 3. Pull the power supply out using the handle provided. 4. Replace the failed power module with the same model. 5. Push the new power supply module into the power bay until you hear a click. 6. Reconnect the power cord, power up the system and replace the chassis cover. 5-16 5-17