SC815 Chassis Manual Figure 6-5. Installing into an Open Rack Note: figures are for illustrative purposes only. Always install servers into racks from the bottom up. Installing the Chassis into a Mid-Mount Position (Telco) Rack 1. Use the two L-shaped brackets on either side of the chassis (four total). 2. Determine how far the chassis will extend out the front of the rack. Larger chassis should be positioned to balance the weight between front and back. If a bezel is included on your server, remove it. 3. Attach the two front brackets to each side of the chassis, then the two rear brackets positioned with just enough space to accommodate the width of the telco rack. 4.
Finish by sliding the chassis into the rack and tightening the brackets to the rack. 6-8