SC815 Chassis Manual Appendix B: BPN-SAS-815TQ Backplane Specifications B-3 An Important Note to Users B-5 Front Connectors All images and layouts shown in this user's guide are based upon the latest PCB Revision available at the time of publishing. The card you have received may or may not look exactly the same as the graphics shown in this manual.
1 1 1 3 1 6 REV 1.00 SAS815TQ S UPER R JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET JP46 1 5 1 4 R144 JP29 JP18 D3 JP42 JP33 JP34 JP40 JP51 MH2 M46 M9 M15 B-4 Introduction to the BPN-SAS-815TQ Backplane JP10 +5V GND GND +12V #3 #0 J8 1 2 1 2 +5V +12V +5V +12V J9 J10 JP26 JP47 #2 J7 #1 J6 J5 JP44 SIDEBAND 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN 1 8 Figure B-1. Front Connectors 1 7 The BPN-SAS-815TQ backplane has been designed to utilize the most up-to-date technology available, providing your system with reliable, high-quality performance. This manual reflects BPN-SAS-815TQ Revision 1.00, the most current release avail- able at the time of publication.
Always refer to the Supermicro website at www.su- permicro.com for the latest updates, compatible parts and supported configurations. SAS Ports JP10 +5V GND GND +12V REV 1.00 SAS815TQ S UPER R +5V +12V +5V +12V JP47 JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET #2 JP46 J7 R144 JP29 JP18 D3 JP42 JP33 JP34 JP40 JP51 SIDEBAND MH2 M46 M9 M15 #3 #0 1 10 1 12 1 11 J8 J9 J10 JP26 #1 J6 J5 1 9 JP44 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN Figure B-2. SAS Ports 1. Power Connectors (4-pin): JP10 2. CD-ROM/Floppy Drive Power Connector: J9 and J10 3. JTAG JP47 4. Upgrade Connector: JP46 5. MG9071 Chip 6. Sideband JP51 7. I 2 C Connector JP44 8. ACT_IN JP26 9. SAS Port #0 J5 10. SAS Port #1 J6 11.
SAS Port #2 J7 12. SAS Port #3 J8 B-2 B-3