SC825 Chassis Manual C-6 Rear Jumpers JP43 + + + + + + JP18 JP29 JP50 GND GND +12V +5V GND GND +12V +5V GND GND +12V +5V GND GND +12V +5V + + 1 1 JP36 48 BAR CODE REV 2.0 SAS825TQ REV 2.0 SAS825TQ 1 1 BAR CODE ACT_IN ACT_IN #2 2 I C #2 I C 2 SIDEBAND #2 SIDEBAND #2 + + + + JP29:9072 RESET JP29:9072 RESET JP37 JP38 + + + + + + + + + + + + + + + + 1 1 16 16 JP33 32 32 48 JP34 I C 2 I C 2 #1 #1 SIDEBAND #1 SIDEBAND #1 JP42 JP41 JP40 Figure C-3. Jumpers Explanation of Jumpers To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector.
Pin 1 is identified with a square solder pad on the printed circuit board. Note : On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Connector Pins 3 2 1 Jumper 3 2 1 Setting D-6 Jumper Settings Jumper Jumper Settings Note JP29 Open (Jumper off the pins): Default Closed (Jumper on the pins): Reset MG9072 chip reset JP18 Not used