SC825M(B) Chassis Manual B-6 Rear Jumper Locations and Pin Definitions #2 J35 J35 #1 J29 SIDEBAND JP51 JP10 +12V GND GND +5V J6 R S UPER LED TEST J10 J9 +12V GND +5V +12V GND +5V J7 REV 1.02 BPN-SAS-825MTQ UPGRADE JP46 RESET J29 J8 #0 J8 Figure B-2. BPN-SAS-825MTQ Rear Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Jumper 3 2 1 Setting Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins.
B-6 Jumper Settings Jumper Jumper Settings Note J35 Open = Default Closed = Enabled Activity LED Test J29 Open = Default Closed = Reset Chip Reset