Chapter 5: Chassis Setup SAS/SATA Hard Drive 6 Drive Carrier 4 6 Use a hard, stable surface when installing the hard drive. Figure 5-4. Installing a Drive into a Hard Drive Carrier 3. Place the hard drive carrier on a flat, stable surface such as a desk or work bench. 4. Slide the hard drive into the carrier with the printed circuit board side facing down. 5. Carefully align the mounting holes in the hard drive and the carrier. Make sure the bottom of the hard drive and bottom of the hard drive carrier are flush. 6. Secure the hard drive using all six screws. 7. Replace the drive carrier into the chassis. Make sure to close the drive carrier using the drive carrier handle. 5-5