Chapter 6: Rack Installation Chapter 6 Rack Installation This chapter provides instructions and tips for installing the chassis into a rack. 6-1 Preparing for Setup Please read this section in its entirety before beginning the installation procedure. Choosing a Setup Location Decide on a suitable location for the rack. It should be a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and electromagnetic fields are generated. Place it near a grounded power outlet. Leave at least 25 inches clearance in front of the rack to open the front door completely.
Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient airflow and ease in servicing. Install in a restricted access location, such as a dedicated equipment room or service closet. Ambient Operating Temperature If installed in a closed or multi-unit rack assembly, the ambient operating tempera ture of the rack environment may be greater than the ambient temperature of the room. Install the equipment in an environment compatible with the manufacturer’s maximum rated ambient temperature (TMRA). This product is for installation only in a Restricted Access Location (dedicated equipment rooms, service closets and similar environments).
Adequate Airflow Equipment should be mounted into a rack so that the amount of airflow required for safe operation is not compromised. 6-1