Supermicro SC835 — C-6 Front Connector and Pin Definitions

Appendix C: SAS-833TQ Backplane Specifications C-6 Front Connector and Pin Definitions 1. Upgrade Connector The upgrade connector, designated JP69, is used for manufacturer's diagnostic purposes only. 2. I 2 C Connectors The I 2 C connectors, designated JP37 and JP95, are used to monitor HDD activity and status. See the table on the right for pin defi­ nitions. 3. Sideband Headers The sideband headers are designated JP66 and JP68. For SES-2 to work properly, you must connect an 8-pin sideband cable. See the table to the right for pin definitions. NOTE: SGPIO is the default setting for this backplane. 4.

MG9072 Chip The MG9072 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. C-5 I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection Sideband Headers Pin # Definition Pin # Definition 2 SGPIO: SDIN I2C: Backplane Addressing (SB5) 1 Controller ID (SB6) 4 SGPIO: SDOUT I2C: Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SGPIO: SLOAD I2C:SDA (SB1) 8 Backplane ID (SB7) 7 SGPIO: SCLOCK I2C:SCL (SB0) 10 No Connec­ tion 9 No Connection