SC835 Chassis Manual D-6 Front Connector Pin Definitions #1. CPLD Chip The CPLD is an enclosure management chip that supports the SGPIO and LED manage ment. #2. CPLD Upgrade Port The CPLD programming port, designated J11, is used only by the manufacturer to upgrade the CPLD. #3. - 4. MiniSAS HD Connectors The SAS ports are used to connect the SAS drive cables. The 2 ports are designated JSM0, for drives at SAS #0-#3, and JSM1, for drives at SAS #4-#7 (see section 2-4 for SAS drive loca tions). Each port is also compatible with SATA drives. However, mixing SAS3 and SATA drives in the same enclosure is not recommended. #5. - 6.
Backplane Main Power Connectors The 4-pin connectors, designated JPW1 and JPW2, provide power to the backplane. See the table on the right for pin definitions. C-4 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V